PTP Micrococker bolt, pin and sled

Another case of an old, worn marker. The customer needed a new sled, and wanted a different pin orientation than the original, which required a new bolt and pin. The sled was particularly tricky because there’s a threaded hole with very little meat around it on the front face (left as shown in the above picture), which I ended up making at the end of everything. If I did it again, I would change the workholding so that was done first, then the exterior dimensions were milled. Picture below shows it mounted on the marker before anodizing.micrococker

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s