Got the Haimer in the spindle and off we go. Note that nothing here is statistically significant and the equipment being used is really not the right stuff (a Faro arm, or at least a large surface plate and a good indicator, would be a better choice but aren’t available), so take the results as you will. This is good enough for the work this machine does, and to confirm I’ve spent my money less poorly than I would otherwise.
Jaw alignment: measured at 0.0005″ off over 4″. I got the fixed jaw flat, zeroed out the indicator on the left side of the moving jaw, and got the reading shown below on the right side.
Parallelism (to spindle): 0.0006″ over ~5″. The bed drops away on the side further from the spindle. I will admit that it’s just as likely this is the machine. I didn’t have a piece of ground stock to test it lying around.
Clamping displacement: 0.000″. Unclamped and clamped shown below.
I’m happy with it so far, time to drop in some soft jaws and make some parts.